Florida State University Researchers Develop Cheaper Material LEDs

A team of Florida State University materials researchers has developed a new type of light-emitting diode, or LED, using an organic-inorganic hybrid that could lead to cheaper, brighter and mass produced lights and displays in the future.

Assistant Professor of Physics Hanwei Gao and Associate Professor of Chemical Engineering Biwu Ma are using a class of materials called organometal halide perovskites to build a highly functioning LED. They lay out their findings in the journal Advanced Materials.

Organometal halide perovskites used to make the new LEDs. (Photo courtesy of Florida State University)

“Early work suggested perovskites could be a promising material to build LEDs,” Gao said. “But, the performance was not up to their potential. We believed there was significant room for improvement.”

Perovskites are any materials with the same type of crystal structure as calcium titanium oxide. Other researchers experimented with perovskites to build LEDs in the past but could not build particularly effective ones. Gao and Ma believed this organic-inorganic hybrid could perform better, if the formula could be appropriately tweaked.

“When we thought about this class of material, we knew it should perform better than this,” Ma said. “We came up with our novel approach to solve some critical problems and get a high-performance LED.”

After months of experiments using synthetic chemistry to fine-tune the material properties and device engineering to control the device architectures, they ultimately created an LED that performed even better than expected.

The material glowed exceptionally bright.

It is measured at about 10,000 candelas per square meter at a driving voltage of 12V — candelas are the unit of measurement for luminescence. As a benchmark, LEDs glowing at about 400 candelas per square meter are sufficiently bright for computer screens.

“Such exceptional brightness is, to a large extent, owing to the inherent high luminescent efficiency of this surface-treated, highly crystalline nanomaterial,” Gao said.

It was also quick and easy to produce.

Gao and Ma can produce the material in about an hour in the lab and have a full device created and tested in about half a day.

Additionally, while bare hybrid perovskites tend to be unstable in humid air, the nanostructured perovskites exhibit remarkable stability in ambient environment because of the purposely designed surface chemistry. Such chemical stability largely reduces the requirement of sophisticated infrastructure to produce this new type of LEDs and could be of huge benefit for cost-effective manufacturing in the future.

The research is crucial to the advance of LED technology, which is fast becoming an avenue to reduce the country’s electric consumption. LED lighting is already sold in stores, but widespread adoption has been slow because of the costs associated with the material and the quality. 

But, LED lights do save energy. 

According to the U.S. Department of Energy, residential LED lighting uses at least 75 percent less energy than regular incandescent lighting. 

“If you can get a low cost, high performing LED, everyone will go for it,” Ma said. “For industry, our approach has a big advantage in that earth abundant materials can be processed in an economic way to make the products.”

Gao and Ma came to FSU as part of the Energy and Materials Strategic Initiative with the mission of producing high tech materials for new generation, energy sustainable technology. By chance, they wound up with offices next to each other and began collaborating.

They also work with Assistant Professor of Industrial and Manufacturing Engineering Zhibin Yu, who also focuses on LED technology research, as well as Assistant Professor of Chemistry Kenneth Hanson, who is a co-author on this current paper.

“Gao and Ma, as well as Ken Hanson, are members of a cohort of 11 new faculty hires in the Energy and Materials Strategic Hiring Initiative,” said Associate Vice President for Research W. Ross Ellington. “The present work, as well as other recent, joint publications, indicates that the desired synergies are being achieved in this effort.”

In addition to Gao and Ma, other FSU researchers involved with the experiments are Hanson, post-doctoral research associates Yichuan Ling and Zhao Yuan, and graduate students Yu Tian, Xi Wang and Jamie C. Wang.

Disclaimers of Warranties
1. The website does not warrant the following:
1.1 The services from the website meets your requirement;
1.2 The accuracy, completeness, or timeliness of the service;
1.3 The accuracy, reliability of conclusions drawn from using the service;
1.4 The accuracy, completeness, or timeliness, or security of any information that you download from the website
2. The services provided by the website is intended for your reference only. The website shall be not be responsible for investment decisions, damages, or other losses resulting from use of the website or the information contained therein<
Proprietary Rights
You may not reproduce, modify, create derivative works from, display, perform, publish, distribute, disseminate, broadcast or circulate to any third party, any materials contained on the services without the express prior written consent of the website or its legal owner.

Tokushima, Japan - 6 March 2024: Nichia, the world's largest LED manufacturer and inventor of the high-brightness blue and white LED, has started mass production of the new UV-B (308nm) and UV-A (330nm) LEDs in its popular 434 Series packa... READ MORE

New XLamp® S Line LEDs enhance growth, last longer, lower energy costs Horticulture and other forms of agricultural lighting require application-tuned ratios of spectral content, high efficacy and long lifetimes. Whether you are interested... READ MORE